Portable Period Pain Reliever (I-200L)

Instruction for Relieving Pain

01

Connect Controller with Pad

Connect the patch using the connecting cord to the jack under the device

02

Stick Pad on the Aching Spot

1) Set the top of the pad on the basis of the belly button and Attach the pad. (Set the position naturally for good heat therapy.)
2) Stick the pad well on the desired spot.
3) Fix with stomach belt it necessary.

03

Power On

1) Check the power switch is off on the lower right of the controller.
2) Pull off the battery cover and fit the metal contact of battery info the charging part and press it down. Then fit the cover into the groove and fix it.
3) Side up the switch on the unit to turn on the power.
4) Check charging state. Use after charging by 24PIN charger or 24 USB cable 24PIN(24PIN: charger and charging cable are separately sold)

04

Mode Selection

1) Period pain relief mode: basic time 20 minutes
- Press the ① button once for strong mode A.
- Press it twice mode B.
- Press it three-time mode C.
2) Heat mode: basic time 20 minutes
3) You can use relief mode and heat mode at once or separately by patch

05

Adjust Strength Level(1~15 Level)

Adjust the strength level of selected mode using upper-lelt button

Instruction for Home-Use Low Frequency

01

Connect Patch & the Controller with Patch

1) Connect the patch connector to the patch on the patch at a flat place.
2) Connect the patch using the connecting cord to the jack under the device.

02

Stick Pad on the Aching Spot

1) Stick the pad well on the desired spot symmetrically centering after removing the protection film.
2) Connect the pad using the connecting cord to the jack under the device.

03

Power In

1) Check the power switch is off on the lower right of the controller.
2) Pull of the battery cover and fit the metal contact of battery info the charging part and press it down. Then fit the cover into the groove and fix it.
3) Side up the switch on the unit to turn on the power.
4) Check the charging state. Use after charging by 24PIN charger or 24 USB cable 24PIN
(24PIN: charger and charging cable are separately sold)

04

Mode Selection

1) Home-use Low-Frequency Mode: Basic time 20 minutes.
- Press the ① Button once for pressing mode. twice for tapping mode. three times for massaging mode. and four times for auto mode.
2) Using heating mode is unable by patch.

05

Adjust Strength Level(1~15 Level)

Adjust the strength level of selected mode using upper-lelt button